Hello,
Can any one help me. I have this small Hurco Hawk 2u
The control is ultipath
now the hard drive was bad in this when i got it and i have been using it as a manual mill for 6months or so but i want to get the cnc up and running now
The hard dive will not boot I have had the hard dive recovered and got as much data of it as i can. I have got a new hard drive in to it and loaded windows 98 (i belive the original was Windows 95 but i didnt have this) and it boots up windows. I have then copied all the dater from the old hard drive over and i can open the sortware but seams that only some bits of it work so i think to much is missing.
I have spoken with hurco and they seam to know nothing about this type of controller now. however they have send me 2 floppy disk (ultipath masters)
Disk one has Continue Execprog.001 and hurco.LDR on it
Disk 2 has execprog.002 and led_ed.LAN on it
I have tryed to boot these disks on Windows 98 and nothing happens
it seams that this controller from what I have been reading is verfy simuler to BMC30 but with a windows .... Is this correct? and if so do I load the software in the same kind of way?
I have found this https://docs.google.com/document/d/1...Byszi9LLU/edit
That says how to load a BMC30 and the files and names seam to very very simuler....
but if i need two partitions one C:/EXECUTIVE_1 and one D: /PART_PROGS where has windows got to be installed?
I do now have a copy of windows 95 that i can try but any help would be greatly appreciated from any one that knows any thing or that has one of these that might be able to help with DATA
I would like to try every thing i can on this controller before considering a retro fit
Thank you in advance