Almost complete 3 axis servo system from a Techno Isle gantry router. Working area was 3 ft x 5 ft. I say almost because the limit switches are gone. It was a running system when removed from service. I have the control box, servos, cables, interface card, software (g-code and native mastercam nci) and a manual. I also have (4) 1" thompson rails and risers with (8) bearings. Probably have some ball screws, not the best but not the worst. Just trying to figure out what the stuff is worth or if it's worth nothing then I'll just hang on to it.

Thanks

http://saftysign.ir/Shop-signs