Saturday morning I powered up my PCNC 1100, but instead of pathpilot launching as normal a window popped up saying "the Mesa Interface requires reprogramming with new firmware. Click OK to proceed."
Upon clicking ok it attempts to write to the mesa and fails.
After several reboots it now no longer recognizes the mesa card at all.
I have tried swapping the card to different slots as well as cleaning, but neither works.
I checked the 3.3v pin to ground and it is measuring 3.35v
The two leds on the mesa cards remain on when the computer is powered.
The jumpers on the card are all in the correct position.
The controller is the "standard" tormach pathpilot controller purchased in fall 2017 (along with the mill)
Can anyone help with this? I do not know if this is a bad mesa card or software issue or some other hardware failure.
I emailed tormach support and have yet to here from them, I need to get this working asap.