You're welcome to come out some time!
Just got a CNC Lathe up and running to make custom knobs for these bad boyz
You're welcome to come out some time!
Just got a CNC Lathe up and running to make custom knobs for these bad boyz
"It's only funny until some one get's hurt, and then it's just hilarious!!" Mike Patton - Faith No More Ricochet
i'll take you up on the invite sometime , it would be great if you could give me a few pointers on the warlock i plan to build at some point that my attention span will allow , i can play them suckers a lil bit but i don't know crap about building them
in regard to the one at skinner how fine do you machine the surface before polishing , it's been my experience that a few tenths too deep can really show on a shiney aluminum surface , so i've been thinking either you leave very little before polishing or in a past life was possibly a mold maker and you are really patient and good at hand polishing , or both
A poet knows no boundary yet he is bound to the boundaries of ones own mind !! ........
The rad's are cut with router bits, and when I set up the first one, I take my time when blending the tool in, and I will if anything err on the side of caution. The guy who does the chrome, does any blending required. I like to keep my shop clean so polishing wheels dont' really go with that environment.
The Rad on the back side is run along the neck joint to make access to the higher frets unobstructed too. It plays stellar although people complain about the weight.
It's still lighter than my LP Custom.
"It's only funny until some one get's hurt, and then it's just hilarious!!" Mike Patton - Faith No More Ricochet
Hello,
Can anyone point me to a source (paid or free) where I can download dxfs of popular guitar body styles (Fender, Gibson, etc)?
Thanks!
If you cut it to small you can always nail another piece on the end, but if you cut it to big... then what the hell you gonna do?
Steven
Good to see the thread revived.
If you get a PDF it can be converted into a DXF
GitarreBassBau.de • Thema anzeigen - Schablonen und Zeichnungen • Gitarrenbau, Bassbau
Here is my version of Aluminum machined from billets
https://picasaweb.google.com/1064275...920/July282012
Been doing this too long
I put some good links in the "Let's build a strat" forum:
http://www.cnczone.com/forums/musica...ml#post1149002
Man I never get tired of looking at the guitar builds here!
cheers,
Ian
It's rumoured that everytime someone buys a TB6560 based board, an engineer cries!
Very nice...but for Heavy Metal I would use brass.
Revive a post
are there interested members here
Been doing this too long