Hi All
I see that most posts say that one should first select the post processor from the drop down menu. However I cannot see any drop down menu in Aspire at all. Does anyone know where to select from? I need to select Mach3
Kind Regards
Hi All
I see that most posts say that one should first select the post processor from the drop down menu. However I cannot see any drop down menu in Aspire at all. Does anyone know where to select from? I need to select Mach3
Kind Regards
Not sure if Aspire 3 is the same as the current versions. When you save your tool paths there is a option to select for post. Expand this and select the Mach 2 post.
Ed
When you click on icon for saving toolpath, you will have the opportunity to select post. See attached picture.
Make no mistake between my personality and my attitude.
My personality is who I am. My attitude depends on who you are.
Hi
Thank you for the reply. But nowhere can I see this menu. here are two pics of the open Aspire3.
You need to open the toolpath tab in the upper right corner, create toolpaths, and save them. It's while saving the toolpaths that you'll see the post processor list..
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thank you Ger21. Sometimes little things get overlooked! Only realized the toolpath menu in the top right hand corner