Hello All,
I bought myself a Emco VMC 100 with Emcotronic TM02 controller.
According to the seller, the machine stood still for over a year.
Now i was trying to start the machine and encountered some problems.
On start:
pressing the "Aux on" button does notting.
The control is in Edit mode with following errors:
alarm 130: value out of range / invalid input data.
alarm 460: reference position active.
after pressing the reset button:
alarm 460 stays on the screen.
When i press the manual button the following errors appear.
alarm 780: safety lock active.
alarm 460: reference position active.
I did some research and there is the possibility that the MSD data is lost and i don't have a tape to read these back in.
Any help and sugestions are welcome.
Thanx in Advance.
Araya