I have a Koyo 8 Axis grinder w/Fanuc Power Mate d control. Problem I have a seperate CRT for each Control (4 alltogether) I had a control failure with one of them, and I installed the new control BUT I can not get it to boot to the CNC so i can load the new program into the control. I am not use to these Powermates. But there is a flashcard port on each one to load the main PMC. How can I do this with out getting to the PWE or other screens I need.
In other words how do you load memory into the Servo Control???
Please help if you can folks
Bluesman