Originally Posted by
billsnogo
I create multiple UCS for each part, one for each operation.
I have attached a picture of an example. In this my TOP ucs is in the upper right hand corner of the part. I created another ucs for another op and you can see the location of the ucs is almost at the bottom of the part and off to the left of the top ucs.
I like to use points for most of my dimensions, and on this one my active ucs is the second one I have created, but the dimension of the point I did always goes back to the xyz location of the top ucs, not the active ucs. Makes it very hard on me as I do
not usually have prints to work off of.
edit: I attached a zipped bobcad file, similar but not the same because I did not think of saving the example of the pic but same situation.