[fourmi]

Hi
So first 1000 sorry to post this subject maybe at the wrong place (and sorry for my english...)
So I am french and that done pufff 1 year I buy a CNC on ebay

FOR WHAT IS DONE THIS CNC
This CNC is for done ANTHILL (yes that is strange)
but look at this picture and you will understand why a CNC could be very interesting to realise ANTHILL in quantity
http://photos.fourmis.free.fr/media/...balabkabka.jpg
ANTHILL can be in "YTONG" (Beton cellulaire in french but don t know the word in english) in YEAST, WOOD... (it depends of the ant species)

THE CNC PROBLEM

1. THE STEPPER DRIVER

So to This CNC come from from US (110 V) so I have to converse it to 220 V (so that is done)
This CNC have a Xylotex control card (XS-3525/8S-3) and that is my big problem because I have well the PDF of this card but I have lot of problems to understand it
http://www.xylotex.com/XS3525V202.pdf
For the moment the electronic is like that
http://photos.fourmis.free.fr/media/...rs_Voltage.jpg

1. THE MOTORS

STEPPING MOTOR
TYPE KP56LM2-097
DC 6 V
1,8 DEG/STEP
http://photos.fourmis.free.fr/media/393/Moteur_Y.JPG

WHAT I NEED LIKE HELP

Well I will need help to know if motors are good and to know what I have to do before connect motors
Actually I don t understand the manual user (PDF) so if somebody can explain me what I don t understand and what is important in the manual
Well I think it is a good start

THANKS A LOT !!

[NinerSevenTango]

Try asking your question in this forum:

http://www.cnczone.com/forums/forumdisplay.php?f=82

Good Luck!

[fourmi]

thanks !!!

[fourmi]

Hum somebody to help me to configure the CNC (motors and card)
What VREF I have to put for this motors of 6 V DV ?

[Oldmanandhistoy]

Hi,

I will do my best to help.

What is the Amps/phase of your motors?
You need this to set the VREF.

John

[Oldmanandhistoy]

I have done a google for your motors and they are rated 1.2Amps/phase unipolar.
If you are going to run them bipolar series the VREF needs to be set to 1.2Volts.

1.2 Amps times 0.7 times 1.44 = 1.2V

John

[fourmi]

Ah thanks (sorry for the late) !!!
Thanks a lot because I am really lose with CNC technics words and the english the mix is (nuts) too for me
Well I think alone I will never found the right VREF lol

If you are going to run them bipolar series the VREF needs to be set to 1.2Volts.

Hum Bipolar unipolar ? I have a choice to do ?
Have you a test to verify motors are ok ?
In the PDF they speak of "jumper" so how to configure them ? How dispose them ? And they are done for what ?
Thanks a lot Oldmanandhistoy