Probing routine out of Fusion 360. I have the ITTP from https://hallmarkdesign.co.nz/probe and want to set up a probing routine at the start of each part for a second operation. Basically I need to validate and reset G54 due to the part being flipped over and there being some slight +/- variables from OP 1. When I try to CAM it out in Fusion 360 the post fails. Anyone doing this?

Tormach 1100M w/ the ITTP probe

This is what post out (cannot find the "log" it's talking about).

%
(OP 2)
(T99 D=0.156 CR=0.078 - ZMIN=-0.3987 - probe)
G90 G54 G64 G50 G17 G40 G80 G94 G91.1 G49
G20 (Inch)
G30

N10(Probe1)
T99 G43 H99 M6
(ITTP Probe)
M5 M9 (SPINDLE IS OFF)
G54
G0 X0.5625 Y0.2779
G0 Z6.2

G30
M30
%
!Error: Failed to post data. See log for details.