hi everyone,
i have a plasma table with nema34 motors on it.
these have at certain speed vibrations.
i would like to add some inertia dampener to help that.
here's where i got the idea from:
https://www.cnczone.com/forums/stepp...er-damper.html
issue is that my stepper motors only have 1 shaft.
the back of the motor has a round detent of 30mm in diameter and about 3mm deep.
at the bottom of this detent there is a thin plate (i can see it move when i push on it).
here's a picture:
https://www.cnczone.com/forums/attac...d=412332&stc=1
does anybody know if it's possible to attach a dampener to this motor
this is what i wanna add to the motor:
https://www.cnczone.com/forums/attac...d=412334&stc=1
does anyone know what there is behind the thin plate?
could i attach the dampener to whatever there is?
thank you