586,116 active members*
3,510 visitors online*
Register for free
Login

Thread: OMNI 1530 Spindle air pressure

Results 1 to 6 of 6

Threaded View

  1. 03-05-2019, 08:09 PM #1
    matthewomeara
    matthewomeara is offline
    Join Date
    Dec 2018
    Posts
    17

    OMNI 1530 Spindle air pressure

    My OMNI 1530 has been up and running for about a month now. A few days ago I tried to resurface my spoil board and the depth was all over the place. The bit was slowly sinking deeper over the first half of the table and then suddenly raised back up fairly quickly. I've seen this same pattern as I've run parts since then. I suspect it's the spindle that's the source of the problem (and not the vacuum). There appears to be a pressure regulator for the spindle, but the manual from OMNI does not provide any instructions on what to set it at. Currently, it's set very low (almost to zero).
    Attached Thumbnails Attached Thumbnails spindle air.jpg  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Omni 1530 ordered and ongoing log of the process
    By gfacer2 in forum Omni CNC
    Replies: 131
    Last Post: 11-18-2020, 07:40 AM
  2. OMNI 1530 Tool Change Interference
    By matthewomeara in forum Omni CNC
    Replies: 8
    Last Post: 02-23-2019, 04:02 AM
  3. NEW - Omni CNC Router 1530 won't respond to Mach3
    By HELVEY in forum Omni CNC
    Replies: 2
    Last Post: 11-03-2017, 09:02 PM
  4. NEW OMNI 1530 ATC HAPPY OWNER
    By karloterrazas in forum Omni CNC
    Replies: 1
    Last Post: 10-17-2017, 04:42 PM
  5. New Omni 1530 just about ready
    By RUSTY2 in forum Omni CNC
    Replies: 6
    Last Post: 11-08-2016, 08:16 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules