Re: Purchased a used CNC Vacuum Router Table, Does anyone know what brand or model ?
Looks like a substantial machine as far as the mechanical goes. But the controls are a disaster area, looks like someone did a hash job retrofit. The board in the panel almost looks like MultiCam, but it could be something totally different. Some pictures of the main controller board might be helpful. Looks like it might have a VFD on the far right, but I can't read the label on the side. If that is a VFD it would not be connected to anything, there is no motor for it to run.
If it were mine, I would get Mach3 running on it and not worry about finding any documentation for it.
Jim Dawson
Sandy, Oregon, USA