Ordered a used draw tube on ebay. Doesn't fit in my spindle bore. My spindle bore is about 1.377, maybe few tenths over that. The drawtube varies between 1.378 and 1.379. I kind of assumed most 5c draw tubes should have the same general clearance, but apparently not. I would try another used on ebay, but not sure what's gonna fit. This one didn't have a brand name listed. Is it odd for a draw tube to be a few thou over 1 3/8? Or is it my spindle thats odd and they are usually bored more than 2 thou over 1 3/8?