8.2 Push-button speed control
(1) servo enable (SON) OFF. The internal enable (Pn003=0) or external wiring control enables the
OFF to be in a state. It is recommended that the CN2 control interface do not receive any control
lines.
(2) switch on the circuit power, the driver of the 5 digital tube display light, and if there
is an alarm, the decimal point has been flashing, and display alarm code AL-xx. Please check the
connection.
(3) to confirm that no alarms and any exceptions have been entered into the auxiliary mode Fn002
subdirectory JOG_1 (specific operations and parameter settings, see Chapter third, section 3.4.4,
Fn002, trial operation). After entering the lower directory of JOG_1, the display is shown as
0 (unit: r/min), and the motor has been energized. Through the key or key, the input motor will
be running at speed, the motor will run at this speed. To exit this operation, you need to perform
JOG_2 operations.