hi, this is what i found about that error :
Code:
ALARM D 4720 Dual cycle start button interlock
In dual palm operations, rise of 2 pieces of button time has slipped more than the fixed time.
1->Rise time of 2 pieces of door close button has slipped more than 1[s].
2->On the door area sensor installation specification, an operation that is inhibited with the area sensor shaded was
performed with the area sensor shaded.
maybe it is generated because you put some files in MD0 ? that error is reffering to a non-standard method for starting programs, maybe to dual buttons ? i don't know ...
if p1 & p2 are in floppy folder ( perhaps device uso ), and res.lib is in md0, then your program should be ( something ) like this :
Code:
{PSELECT} [fm],[pm],[fs],[n](CR) or (LF)
PSELECT US0:P1.MIN,,MD0:RES.LIB
PSELECT US0:P2.MIN,,MD0:RES.LIB
look, if you wanna test this, then let's make some trial programs, and begin a secvential testing :
file p1.min
V1 = 1
CALL OSUB
M02
file p2.min
V1 = 2
CALL OSUB
M02
file res.ssb
OSUB
V2 = V2 + V1
RTS
now put p1.min, p2.min and res.ssb in md1, and run this
Code:
VSET V2 = 0
PSELECT P1.MIN
PSELECT P2.MIN
if V2 will be 3, then move res.ssb from md1 to md0, and run this :
Code:
VSET V2 = 0
PSELECT P1.MIN,,MD0:RES.SSB
PSELECT P2.MIN,,MD0:RES.SSB
if V2 will be 3, then move *.min files, from MD1 to US0 ( floppy, etc ), and run this :
Code:
VSET V2 = 0
PSELECT US0:P1.MIN,,MD0:RES.SSB
PSELECT US0:P2.MIN,,MD0:RES.SSB
if V2 will be 3, then convert res.ssb to res.lib, register it, power-off-on, and run this :
Code:
VSET V2 = 0
PSELECT US0:P1.MIN,,MD0:RES.LIB
PSELECT US0:P2.MIN,,MD0:RES.LIB
if v2 will be 3, then everything is ok
maybe you will reach this point
however, i am afraid that it won't work, but i am not sure, because :
this requires the controller to register a file, for auto-loading, from a non master device, thus <> MD1
i tried this a while ago, and i did not succed :
https://www.cnczone.com/forums/okuma...lways-md1.html
kindly