[chet470]

https://www.linkedin.com/feed/update/urn:li:activity:6517083616902737920

[Jim Dawson]

I think the link you want is https://www.maiden-creek.com/blog/ma...the-dirty-word It's possible to get there from your link, but requires a bit of monkey motion.

I would be offended if I were referred to as an operator.

Now this afternoon I guess I was an operator, load the part, press the green button, inspect the parts. But this morning I modified the drawing, created and edited the G code, then set up the machine and tooling to run the parts, debugged and optimized the run, and QA'd the first article.