I would like to run the dyna stepper driver with Mach3 looking for the pin outs for the stepper driver input and out put .Hope someone has the specs or connection document .Thanks for your help.
I would like to run the dyna stepper driver with Mach3 looking for the pin outs for the stepper driver input and out put .Hope someone has the specs or connection document .Thanks for your help.
Reverse Engineer maybe. Any good Photos of your machine ?
Found this Thread
https://www.cnczone.com/forums/dyna-...onversion.html
Good luck
What is connected to pin 7 ?
Attachment 418196The distribution board out put to the stepper driver what is pin 7 ?Do I need anything besides Plus 48 and ground and the step and direction signals, and 5 volts to get motion ?