Hello
We have a Traub Tnm, TX8F and when we start the machine we receive on the screen this code: SR=2704
Anybody can help?
Thanks
Hello
We have a Traub Tnm, TX8F and when we start the machine we receive on the screen this code: SR=2704
Anybody can help?
Thanks
hello.
I found the reason of my error code from the screen.
the batery from FCA320HLX-V was low.
I found here on the forum a way to reinitialize the MC-161-1 card from the dipswitches.
After that I can see only a screen with " MITSUBISHI CNC, MELDAS 300V SERIES, and copyright rights"
I read something about losting system parameters after batery low.
but i dont have floppy disk drive on my cotrol unit, or any diskette with system parameters.
Can anibody help me please?
hola
buenas tardes,
ami me paso el mismo problema y e encontrado algo para restablecer, el detalle esta en que mi version d eplc del medalss no me deja restablecerlo,
en tu caso encontraste algo?
Hello, Do you have electrical diagram and ladder for this machine? I have one but with no manuals and I can´t find where the fault is.
My email addressis [email protected]
Share or sell, let me know please
Thank you
jolulank
www.doctornumerico.com
cnc physicians