Hi everyone .,
Ok , im not sure if my title tells anything , but not sure how to name that problem..
Lets say that i got a wooden board that is 1 inch thick , im make a pocket that is 6 by 6 inches and ½inch down.
Now if i want to make a slit or a hole in the bottom of my pocket that goes through the material what do i do ?
Cause my current solution is just to make a new pocket but then i need to make the cutter start at 1 inch instead of starting just above the ½inch pocket i already made ?
And yeah , im pretty new with aspire
Thx in advance ,
Kris