[fixtureman1]

Not in this case I would of charged him for the repair and the lose from the resale it was clearly his fault no matter how he damaged the Boards Ethernet Port connection

I should have charged for the bad unit that ever would run a file only move with the arrows and G command. I kept complaining about this and even sent it back for that problem that he never repaired until he had a new buyer. I have a picture of the network cable that shows it was never pulled. I can't help if he damaged it himself when he built it remember there is a strain relieve on that cable.just to keep it from happening. I did say how nice it moved and how quite it was when I used the arrows and G code but that was before I tried to run a file.