Bit of back ground
I have a old (1965) 3 axis Cincinnati
Have installed nema 42 steppers
And DM 2282S drivers
I have this break out board from eBay
https://www.ebay.com.au/itm/5-Axis-C...1294f4057613ab
Problems
I cannot figure which pins to set motors to
2-3 is x
4-5 is a
6-7 is b
8-9 is relay
That’s all I can figure ..??
I cannot get y or z to trigger
Also when wired with all Neg as common and enable pos , Dir pos and Pul pos the driver goes straight in fault mode
I did find the wiring on the net so not sure it’s correct
Hope you guys can help
John P