[L. Sakthivel]

Dear Friends,
What is the remedy to clear the following Alarms in Fanuc 10TF System

SB 010 Graphic ROM Parity
SB 011 Graphic RAM Parity ( Work )
SB 011 Graphic RAM Parity ( Red )
SB 011 Graphic RAM Parity ( Green )
SB 011 Graphic RAM Parity ( Blue )

Any body can suggest for the above problem.

[L. Sakthivel]

Yester Day I checked the Machine, I found it is due to Heat, Iam getting alarm after some times switched ON.
1) Normal Condition Master pcb Shows 1
2) We are able to Home positioning & Spindle run at slow speed
3) after few minutes the above alarm showing but it can reset and continuing the sp. in MDI Mode
4) Monitor getting shake in Display
5) Monitor getting switch off & alarm in Master Pcb is c
6) Alarm c is Transfer error through optical fibre cable
6) Alarm in I/O Board Red Led

Analysed that
During movemet of axis in Rapid & During starting the spindle it is getting off
1) I checked the power supply unit of MDI Unit it is ok
2) Replaced another Power unit in Master
3) Optical cables are good
4) put Fan in front of Master found that alarm duration time little bit increased
I suspect the problem in Graphics section components in Master Pcb

Anybody had this type of problem, Anybody having some other Dignostic method Pl. reply.