Hey All,

I generally post in the Tormach forum, but I have a question about programming a Fusion360 toolpath for woodworking.

I want to cut essentially a single pass dovetail slot in wood, so I would like to be able to cut part way into the slot from one side, at least as deep as the diameter of the cutter, then go to the other side of the stock and continue the cut all the way through.. The purpose of this would be to cut down on splintering and blowout of the stock. Unfortunately even with some googling, I have not come of with an idea of how to accomplish this, on any suggestions would highly appreciated.

I've attached a jpg of an example of what I would like to do.

Thanks
Terry