Well, 120V AC goes to the AC terminals on the drives. PE terminal goes to ground.
120V AC goes to the 24V power supply also.
Not sure the 5V power supply is needed, depends on which board you have. But it won't hurt to wire it in.
Proper fusing is needed for the power supplies. Each drive should also have its own fuse.
The A+, A-, B+, and B- go the the motor wires
The PUL+, PUL-, DIR+, and DIR- go to the appropriate terminals on the board. Exactly which board you have will determine the correct terminals.
The EN and RDY terminals can be ignored for now, but maybe the RDY terminals should be in series with the E-stop switch. I haven't read through the drive manual yet.
Read through this thread, a lot of good information on wiring panels and what they should look like.
https://www.cnczone.com/forums/mecha...77816-cnc.html