I have upgraded my breakout board with a USB MK6-V motion card. I'm having an issue with the enables outputs from Mach3. My gantry mill servo drives are staying enabled. I'm using outputs 3 and 4 for enables pin set. Mach 3 has them showing they are off when estopped. But the terminals stay on. I have checked the pinout 2 and 3 for the outputs on the card. When I hit my estop or click the reset"estop" on Mach3 screen they are staying on. Before the sway they would turn off. Then when cleared from Mach3 screen would enable. I tested the pinout as an output conf. and can turn the terminals on and off just fine. But set as an enable in output setting with the pinout 2 and 3 they just stay on? I would like the drives to be disabled when I hit the estop or as usually click the on screen reset "estop". Maybe the motion card doesn't work with MACH3 enable conf.? Can I set something to use a normal output setting to use as an enable when estopped?
ThX