We're retrofitting a Motion Master that had Fagor 8050 controls. The old system sourced the relays, I'd like to source the relays using Kanalog to include the relay that enables the Glentek drivers. On page 333 there is a relay driver diagram for the Kstep that is set up the way I want to wire the Kanalog.

The Kanalog manual states"Normally a load, such as a relay coil is connected between some appropriate +supply and a Switch input. Therefore when the Switch makes a connection to ground, the load is energized." can the Kanalog be wired power supply sending 24 volts to the Kanalog and the Kanalog sending the 24 volts to the relay that enables the Glentek?

George