okay so I"ve tried re arranging all kinds of G code: T and M6 and M06 and just T commands. I'm using the NC studio post processor from cancam out of fusion. it reads all the rest of the code but when it gets to a T it showes a message on the controller saying"change Tool 1 to tool 2, press stop to change tool or press play to continue".
Pressing stop just doesn't do anything. pressing play repeats the last cycle of G code prior to the toolchange command.
I've spend two days trying to work this out I've watched every ****ty Chinese controller video there is. read every weihong manual, tried every tool change G-code combo. has anyone else encountered this?
please help me if you can. I'm going to make a solid informative NK105G3 English video tutorial when i figure this out!
Cheers
Dan