Hi,

I am trying to figuring out how to do a simple macro to do a manual tool change at cutting POSITION - only z should move to z0.

I have very difficult to see how it works in real life.

So when I cut a job and it stops for a tool change it should automatic go to POSITION z0 wait for me to make a tool change and how do I restart the job again at the new position after I made a new tool probe to old tool position:
x = (variable bed point)
y = (variable bed point)
z = 4 in MM- after my probe macro

I think it must be a very simple macro.

1. go to Z0
2. stop spindle
3. manual tool change
4. Make a new probe to be z4mm over the cutting job.
5. goto old position
6. start spindle

Is it just to push "cycle start" again?

Can some of you please give me some leads... to that macro.