I have an ATC COLOMBO spindle, is there any hope to run this off of 220v any suggestions, opinions welcome, good or bad
I have an ATC COLOMBO spindle, is there any hope to run this off of 220v any suggestions, opinions welcome, good or bad
Transformer and phase converter.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks Guys
yes sorry, 240 AC
I was starting to give up hope, with this spindle, could not find much online, this has given me some direction, I got the spindle for free, it's brand new, so it should be worth it to buy the transformer, otherwise it might be cheaper to buy a china spindle, I will find an electrician to wire it for sure
Name plate says it was made in 11/2000. New to you but not new?