[Fear]

Finally able to hook up the hydraulic pump but now when we start up the machine this error appears and we are unable to clamp/unclamp the chuck or move the turret, I switched up the hydraulic lines to make sure they where in the right place as far as I know. Any info is greatly appreciated.

I took a picture of the error since I cant type it out.

[iNUC]

Finally able to hook up the hydraulic pump but now when we start up the machine this error appears and we are unable to clamp/unclamp the chuck or move the turret, I switched up the hydraulic lines to make sure they where in the right place as far as I know. Any info is greatly appreciated.

I took a picture of the error since I cant type it out.

It seems that you losed all parameter. Need to input them back.
Good luck.

[Fear]

It seems that you losed all parameter. Need to input them back.
Good luck.

Checked all the parameters

[underthetire]

It's just a Estop alarm. Check chip conveyor, all buttons, and overtravel conditions. Did the machine have a barfeeder on it?

[DryRun]

no hydraulic psi check that p and t on lines are right , check pump rotation (phase)

[DryRun]

check that pump is building psi (correct phase UVW) are port and return lines Correct?

[PDAVIS061]

What did you find out on this? same problem here with a CL-200...
also, all of my parameters are in Japanese, but my language is set at 1 for english.

[fordav11]

theres 2 language parameters. one of them affects alarm messages and is set via the option parameters

[MARTINRAUDALES-CNC-TECH]

SOMEONE THAT CAN SHARE THE PARAMETERS FOR A MORI SEIKI CL-200
MACHINE WAS SITTING FOR YEARS AND LOST PARAMETERS. I REALLY APPRECIATE IT
CONTACT ME AT [email protected]
THANX