Originally Posted by
Willybb
Hi Guys
Tried to power up my PCNC1100 today and got the following error, "Mesa Interface Error", "Firmware failed to update properly on Mesa Interface"
Last year I installed the Series 3 Motion Upgrade Kit P/N 32010 and a new Pathpilot Controller P/N 35286. Mill was checked out and everything worked correctly after upgrades.
Now after sitting for a while, Pathpilot will not boot up.
Any sugestions what I should look for?
My Mill is an early one #213 with the following upgrades:
(1) Spindle upgrade.
(2) Series 3 Motion upgrade.
(3) Control Board replacement.
(4) New Pathpilot Controller/Computer.
(5) Cooling Fan upgrade.