I post this cut quality question on the Mach3 forum. I'm just cutting a simple cam 2.5d profile, it sounds super smooth while cutting but I get slightly wavy and bumpy cuts. This is answer I received, but don't know how to correct this in Rhino or Madcam? Suggestions?
Check your Gcode - if the curves are comprised of many straight lines then the answer is with your CAD/CAM and it's Post Processor.
(Vectric, for example, will enable 'curve fit' to replace the many straight lines in an imported dxf and then the final Mach3 post processor will use 'arcs' (G2, G3) for the toolpath).
Thread: Cut quality problem
Results 1 to 20 of 32
Threaded View
-
09-21-2019, 03:26 PM #1
Registered
- Join Date
- May 2006
- Posts
- 343
Cut quality problem
Reply With QuoteSimilar Threads
-
MAX100 cut quality / nozzle build up problem
By MrUno in forum Hypertherm PlasmaReplies: 1Last Post: 08-03-2016, 08:15 AM -
Old problem - CO2 laser cut quality in Acrylic sheet
By Nitrous in forum Laser Engraving / Cutting Machine General TopicsReplies: 0Last Post: 11-08-2015, 05:11 PM -
Quality Engineer/Quality manager - MI
By MachiningJobs in forum Employment OpportunityReplies: 0Last Post: 04-04-2011, 10:51 PM -
Beam quality problem ...
By smartcut in forum Laser Engraving / Cutting Machine General TopicsReplies: 4Last Post: 04-26-2007, 09:17 PM
Tags for this Thread
Posting Permissions
