Hi all
Am in the process of revamping a esab combirex table with a hypertherm ht2000
It's controller is old

So in general is mach3-4 down at the bottom end of plasma controllers or is it as good as high end ones that you may see on 30,000 euro machines
What is the difference,
What can it and can it not do,
Ie, will a high priced one run a gantry smoother / faster,
I know some high end ones may have THC built in,

I have mach3 on another table here and I have no problems with it so I am not putting it DOWN,

Currently we draw on deltacad
Map out on sheetcam
Then send to mach3.
Would high end controllers cut out the like of sheetcam

Just wondering what you get for your buck out of controllers