Hello again,
I have another question for everyone out there which I am struggling to find an answer.
I have a 4mm drill bit attached to my router and I want to drill 8192 4mm holes in an 8ft X 4ft sheet of MDF.
I dont want the bit to plunge down, go round the cirlcle then back out. I want to move to point - plunge down - and lift back out.
I have marked my holes on my drawings with points, not circles so I am not able to just cut auto.
I hope I have been clear in describing my problem and would be very greatful if someone could help me out once again.
Thank you,
Dan.