SoCal CNC enthusiast..
Does anyone have a Parameter Manual or perhaps just a list of Parameters with a brief description so I can experiment with 2 settings.
[email protected]
The items I am trying to experiment with are as follows...
1. I am trying to determine which parameter controls the Fanuc's ability to allow a program being transmitted via RS-232 to overwrite another without the need to delete the current program beforehand. From what I have read it may be 3201 and possibly 2200..... but I would like confirmation before make any changes.
2. I would like to change the parameter value to set a program range that could be protected from the setting in Item 1. above. Like to prevent programs sitting from 100-200 from being overwritten.
I have managed to transfer multiple programs in a single transmission but there must be nothing occupying the memory locations prior...
I would like to load a dozen or so "Standard" parts that are produced on a regular basis in the 100-200 range and protect them using the method in my item 2 request. And then transfer the constantly changing 8-10 programs for each specific job into higher memory locations without the need to worry about old programs being present... They would simply be overwritten without the need manually delete them repeatedly.
First time poster so my apologies if I am submitting this improperly or in the wrong area..