Hello,
I just received some V-Bits I ordered from Ebay Germany. They are supposed to be 90° (0.3mm Flat), 120° (0.1mm Flat) and 150° (0.1mm Flat).
When I received them, something seemed off... I couldn't see the 150° bit. I contacted the seller (incl. pictures) and they told me all the bits look ok. The 150° in the picture on ebay looks very different from any one that I received.
Link to the sellers website:
https://www.gravierbedarf.de/epages/...ucts/V60015001
It's my first time using these kind of V-bits and I just want to know if there is just something I don't understand about these bits or is the seller trying to screw me over?
Here are the pictures i also sent to the seller and a picture of the 150° bit from the listing. I roughly measured the angles by drawing lines over the image in Rhino. The 90° and 120° bits look ok (+/- a few degrees because of the inaccuracy of the image).