I'm using an evaluation version of SW.
I find the CAM in SW to be not as useful and intuitive as I'd like.
Can anyone comment on the differences between the two software?
I am doing relatively simple 2.5D and 3D machining.
I'm using an evaluation version of SW.
I find the CAM in SW to be not as useful and intuitive as I'd like.
Can anyone comment on the differences between the two software?
I am doing relatively simple 2.5D and 3D machining.
Yes, its a good alternative for your described use case. Go give it a download. It's free if you're a startup/educator
Thanks Dub