[robwiacek]

Gerryc
I’m wondering if I can contact you when I’m back in school. Maybe a face time or something?
I. An be in front of the parts and we can talk about it.
I am EST just outside of Philadelphia.
I generally do not teach a class 10:15. - 11:15
AM


Sent from my iPhone using Tapatalk

[john-100]

Thanks gerry

looking at the advert linked to

Motor control output port


P1 - 2.5KHZ the PWM signal, the output port of the parallel port


P2 -- X Axis pulse
P3 -- X Axis direction
P4 -- Y Axis Pulse
P5 -- Y Axis direction
P6 -- Z Axis pulse
P7 -- Z Axis direction
P8 -- A Axis pulse
P9 -- A Axis direction
P14 -- relay port
P16 -- relay port
P17 -- relay port



2: External sensor input interface

Port describle:

P10 -- IN1 E-stop
P11 -- IN2 Alternate
P12 -- IN3 Alternate
P13 -- IN4 3Axis limited
P15 -- IN5 Alternate


4. Power supply for Breakout board ( two ways)

One is 9-32V input (DC, with power light indicator)

Another one is 5V, it is taken from the USB port,


7 way input terminal block -

5V gnd IN1 IN2 IN3 IN4 IN5


Attachment 436646


its not clear if the 5V and gnd terninals are the 5V supply from the USB port

or as I would expect stepped down from the 9-32V input

the GND being the common for the inputs and

the 5V probably the + 5V supply to the input opto-isolator LED's you can use to power

some types of proximity switch



you will need to measure the voltage with just the 9-32V input connected

and then just the USB cable to find out which


John

[robwiacek]

Thanks
I can’t check anything till Tuesday.
I’d there any gauge wire I SHOULD use or CAN’T use?


Sent from my iPhone using Tapatalk