Hi everyone,
Im new at Fanuc, been programming 12 years Siemens but now Im trying Fanuc!
I believe ist Minimum same good as Siemens if not better and I want to go with it now.
Starting with programing on an old old Fanuc control MF-T6 (Mori Seiki),wondering how to define write calc Parameters local global and so on like I was used to with siemens.
I done a bit of Research and found Parameters are Makros at Fanuc written as eg. #100=10.
I have tried in MDI and machine is giving me an Alarm like it doesnt know what I typed in.
OK.
Now I searched again through the internet and found theres a Parameter at System Parameters 9000, where I have changed the NDP to 1 (bit7). Now pushing offset/Setting button twice, a List of variables shows up its called the P-CODE VARIABLES.
OK.
Now I thought well lets try to write #100=10 MDI and check the list afterwards. No->same Alarm as before.
I believe the P-Code list is not the correct list to write to. Am I Right? And where can I find the real Parameter or variable or makro list however its called, i just like to have something Basic simple as any siemens control has the R-Parameters.....
Please Help me,programming without variables/makros is boring..
Thanks