Alignment or What?
I notice this only when I do a pocket or facing the table, but it seems like some type of alignment is slightly off. I'm also thinking it could just be a result of the way end mills are made.
It's only a slight very thin line but I'm wondering why it's only on the top of the cut, even smaller on the bottom, and not on the left, only a shadow on the right(means I can't feel it )
Any Idea's?? I'm pretty sure the routers very level and this was a real soft cut into a cutting board to test and put a picture here.
This was a 3/8ths end mill but it happens with the 1" for the table facing also.
Thanks in advance.
Chris.....Everyday is a Good day.....if you wake up breathing!
Joe's 2006, Mach3, Vectric software.