Setting up a new VFD and 2,2 spindle with Mk 3/4 board. Standard Huanyang units as Planet CNC manuals. For a wood router so no tool coolant required.
I have connected outputs 1, 2 & 6. as shown in the user manual.
But.
In the software example for an Mk 3/4 board on page 7 of 12 in the "OutputBoard_user_manual" It clearly shows that only output pin 1 (on/off) is called. - Direction & Speed are left unassigned? Really need to know if this is actually correct.
Have asked support but just get referred back to manuals which seem not answer this question.
Also how do I test this before connecting up as suggested in the manual. (at the end of the dialogue.)
If you have been here. I would be extremely grateful for your kind advice.