Hi Guys
Tried to power up my PCNC1100 today and got the following error, "Mesa Interface Error", "Firmware failed to update properly on Mesa Interface"
Last year I installed the Series 3 Motion Upgrade Kit P/N 32010 and a new Pathpilot Controller P/N 35286. Mill was checked out and everything worked correctly after upgrades.
Now after sitting for a while, Pathpilot will not boot up.
Any sugestions what I should look for?
My Mill is an early one #213 with the following upgrades:
(1) Spindle upgrade.
(2) Series 3 Motion upgrade.
(3) Control Board replacement.
(4) New Pathpilot Controller/Computer.
(5) Cooling Fan upgrade.