Hey i got my mill yesterday from garant, so far i am quite happy with it here is a pic of it sorry for the mess i am not done yet organizing the space for it, i was expecting to arrive with a set of sleeve collar but i actually got a nice little er25 chuck with it.
To give a little idea it had no problem taking a sidecut .375 deep x .100 wide with a .375 4 flute carbide end mill a finish was quite smooth.
Also the machine is the same as the vario bf20 and is made by the same manufacturer in china "weiss machinery", it also arivved with a test record made by garant and is for the most part square inside 0.015mm or 0.00059in
edit: Ok tried a .5 5 flute carbide end mill at .5 deep x .2 wide side cut the motor was showing sign of slowing down wich i guess is normal and surface finish after the pass was wavy but ok after i came back on it.
Also i check the backlash and i currently have 0.006 on the x axis and 0.005 on the y i have not checked the z axis yet but so far its quite impressive for such a small mill but this will probably change a bit as it break in and the nut loosen there self.