[whoisshredderx]

Hi everyone, I'm working on a new to us Wasino lathe with Fanuc OT control. Our shop's protocol is always to make offsets without a decimal point and I've adjusted the necessary parameters to set the Geometry and wear pages to work this way.

Example: U 5 in the wear page adjusts the diameter .0005" for the tool selected.
I can't figure out how to apply the same input method to the macros though.

Example: currently entering 5 in macro #500 inputs 5.0000"
We want entering 5 in macro #500 to input .0005".

All our other OT machines have been changed in the past to work this way, but that was before my time and I can't find any documentation on what to change.

Thanks in advance for your help!!!

[zavateandu]

you can easily try #500=5/10000