Dear all good day.

I have recently purchased a milling machines for my personal use from an Auction in UK and have them delivered to my house in Cyprus. The milling machines have been stored for about 6 months without any power. its a Bridgeport Interact 1 Mk2

Last Friday they have finally install the Electrical board in my garage (3 phase 415 Volts) and I have powered it up. unfortunately there is no reaction from the machine, control is not responding, and the monitor is not turning on.

Machine was operational before shipping to Cyprus. but most probably got damaged during transportation. Control was not secured and was able to turn.
Unfortunately no manuals or drawings have been delivered with the machine. Control is Heidenhain TNC 2500 and the drivers are DC Servomotors.

I am wondering from where to start the investigation and find what its wrong with it. Shall I check for a new control retrofit solution? Any advice is most welcome.

Pls note that I am not much into electronics.

VBR
Nikos