[Claireck]

Hi, help please >.<

I’ve been using my k40 Chinese laser engraver for over a year now and have only recently come across this issue. The machine plays up half way through engraving. It begins to engrave the image indented. I’ve tried engraving multiple images and the same ’indenting’ occurs. I’ve checked and cleaned the rails, pulley, belt, mirrors and lens. Could a possible lag on my laptop during engraving cause this problem as my laptop freezes at times and is very slow?

Any suggestions would be greatly appreciated. Thank you ~

[rjdj2000]

Best thing to try is a different computer as you said you had checked belts etc. Might want to pop into the K40 groups on Facebook also to see if can figure out the problem. There is good people in there and they can help you out on it more.