Hello Everyone

I would like to reduce some RF interference.
I found this suggested by the people at Gecko
I already did method one and would like to do method 2 and 3
I contacted Digikey and the guy suggested a couple parts

For method two,20 to 50 uH chokes, the guy was not sure, something was unclear for him.

For method three he suggested this parts
https://www.digikey.ca/en/products/d...g/1537L/454745
https://www.digikey.ca/products/en?k...s=399-16383-ND

I found a diagram from google images, not sure if it correct

That capacitor is 100$ cnd and need 4,
he then suggested this one https://www.digikey.com/products/en?...ds=445-8361-ND
can i used the less expensive one, or i need the ceramic one ????

Thanks
Biggs


METHOD ONE:

Use a shielded 5-conductor cable for your motor to drive connection; 4 of the wires go to the motor leads while the 5th goes to the motor case. Return the motor case wire to the drive’s power supply ground connection. Ground the shield to your electronics control box at the control box end only, leaving it disconnected at the drive end.

METHOD TWO:

Install 20 to 50 uH chokes in series with each motor wire as close to the drive as is practical. The choke outputs go to the cable described above.

METHOD THREE:

Install an L-C low pass filter (pi section) from your power supply to the drives. Make L 100uH; make C 1uF non-inductive (multi layer ceramic capacitor). Use this in addition to both of the above.