Hey guys, I'm in the middle of trying to setup home/limit switches on my G0704 mill. I'm using the following proximity switches:

https://www.amazon.ca/gp/product/B00...?ie=UTF8&psc=1

As per the instructions, I had the 12v output on the MX jumper-ed to the Opto1 and Opto2 pins and wired the sensors. The LEDs on the proxys weren't lighting up so i disconnected them and tested them with a 12V battery. They seemed to be working so I checked the pins on the MX between the 12v out and the grnd pins. I am not getting 12V here, so my question is am I overlooking something?

This is the wiring diagram I have been using:
http://www.americanmotiontech.com/Up...ion/MX4660.jpg

Any help would be greatly appreciated.

-Ryan