I make some of my parts using the chamfer op used in the main program on the top side, this works fine as the chamfers are the same size on both sides, I have been flipping the part and chamfering the back side on the same fixture using the same chamfer op as used on the first side, this has worked well until now. I use the "run from here" in pathpilot, now the chamfers are not the same size, one side is heavy the other very light on the back side of the part. It is symetrical so the op should work on either side, I have checked the drawing and fixture and everything checks out.
I am wondering if the "run from here" function can cause this to be off, or what could be the problem?
I drew up a simple test piece and had the same problem, the top chamfer was fine, the bottom was off by a few thou, any insight to this problem is very welcome as I am at a loss as to what is going on......??
Rhino 4 and Sprutcam 7, Sprut has given me problems in the past but this is something new to me..........
any help or insight greatly appreciated.
thanks
edit: PP2.3.6 1100 ser 3